This post explains briefly how to configure FTP storage locations on Amcrest IP Camera.
- Go to Setup > Storage > Destinations > FTP tab
- Enter the details shown below
- Click on test
- “FTP server test failure, list right loss.” means it is successful, observe the test folder getting created in your FTP share.
- Reboot the camera manually. System > Auto Maintain > Manual Reboot
- After reboot, go back to Storage > Destination and enable FTP. You should see the camera data directory is getting created in your FTPshare.
FTP Settings
Address: 10.1.1.20
Port: 21
usenrame: your fto username
password: your ftp password
Directory: /mnt/Kingston/amcrestNote about directory: I found i had to set this to the same path my FTP server is configured. On ProFTP I created a user amcrest using gadmin-proftpd (a GUI tool for configuring ProFTPd).